Forced operation of forced concrete mixer

Forced operation of forced concrete mixer

The forced concrete mixer, the utility model retracts the side arm in the rotation direction of the overall stirring arm layout, so that it lags behind the end arm of the stirring arm group on the same side, so that the working resistance of the side arm is small in actual work. There is no cutting between the mixing drum and the end of the mixing drum, and the driving force of the stirring shaft is also reduced, so that a small-power motor can be assembled, the manufacturing cost is reduced, and the energy consumption is correspondingly reduced.
 
Operating procedures:
          1. Before starting, first check whether the rotating part and the barrel are scratched. If there is scratch, it should be adjusted in time.
          2. The gearbox should be used after the oil is injected. The oil should also be injected into the unloading worm gear and sliding bearing.
          3. Clean the material in the barrel, lock the barrel limit device, and then start the machine. If the running direction is not met after the start, the power should be cut off in time to swap any two phase lines of the wire. And restart.
          4. Put the concrete mixture into the barrel, close the tube cover, and adjust the timing of the time relay according to the mixing time (must be adjusted under power failure).
          5. Press the start button, the spindle will drive the mixing shovel to run, and automatically stop after the set time.
          6. Stop the machine first, then release the material position limit by the handle, then rotate the hand wheel. The worm wheel rotates the barrel to the position where it is easy to discharge, stops the rotation, and then starts the machine to make the spindle run to discharge the material. Until the material is drained to stop the spindle, rotate the handwheel to reset the cylinder.
          7. Clean the barrel and put the water into the barrel to make the spindle run. Clean the residual material in the barrel or wash it with sand.
         I hope that everyone will use it in accordance with the relevant operation methods to avoid problems such as mechanical failure.

2018-09-11 10:52:05